Documents / Official release
This Defense Intelligence Reference Document, dated 14 December 2009, was prepared by the Defense Intelligence Agency's Defense Warning Office under its Advanced Aerospace Weapon System Applications program. It is a technical review of metallic glasses that covers their structure, processing, mechanical behavior and possible aerospace uses. It concludes that composites with ductile dendrites in a glass matrix hold the most promise for structural use. It also finds that widespread aerospace adoption depends on developing new lightweight glass-forming alloys.
From the source: Release of 2026-09-18 Incident: 12/14/09, Las Vegas, Nevada. Released with redactions. This document is a Defense Intelligence Reference Document (DIRD), a technical reference format used by the Defense Intelligence Agency (DIA) to capture baseline knowledge on a specific topic for later analytic use. DIRDs are best understood as reference and synthesis products rather than as original research. It is one of 38 DIRDs produced under the Advanced Aerospace Weapon System Applications Program (AAWSAP) between 2009 and 2011. Because AAWSAP’s scope permitted a broad range of supporting topics, not every DIRD in the series directly concerns aerospace systems or future threat assessment. The following summary reflects the DIRD’s scope and framing at the time of writing and should not be read as implying current validation of the concepts discussed. This DIRD surveys metallic glasses as a potentially important class of aerospace materials and describes their amorphous structure as offering very high strength and unusual manufacturing advantages, but also significant drawbacks, especially poor ductility and fatigue resistance. The document concludes that the most promising aerospace applications are likely to come from metallic-glass-matrix composites rather than single-phase glasses, because these composites can retain high strength while greatly improving fracture toughness and fatigue performance, potentially enough to substitute for high-strength steels in some space-limited structural uses. At the same time, the report judges that broader aerospace use will depend on substantial progress over the next 20–50 years in alloy design, processing, and especially the development of lightweight systems, including aluminum-based options.
UNCLASSIFIED//FOR OFFl@IAL ~SI! 8HLY Casting and Molding Like other alloys, metallic glasses can be cast into net-shape or near-net-shape geometries. Die casting into a permanent (metal) mold-because it provides the rapid heat transfer needed to meet the requirement for relatively rapid cooling - ls the most common casting technique. In most cases, casting is done in either a vacuum or an inert atmosphere to prevent formation of oxide particles that promote crystallization. Conventional casting, however, does not take advantage of the flexibility afforded by the glassy nature of these alloys. If a metallic glass is heated to a temperature above its glass transition temperature, it becomes a supercooled liquid. In this state, the viscosity drops with increasing temperature over a wide range, making it possible to control the viscosity by controlling the temperature. 1 This ability to control the viscosity enables many of the processing techniques commonly used in molding thermoplastic polymers to be applied to metallic glasses (Figure 3). 200 μm Figure 3. Examples of Processing of Metallic Glasses. (a) Microsprlng produced by lithography and (b) thin walled bottle produced by blow molding. Images are courtesy of Professor Jan Schroers (Yale University). There are two important limitations on processing of metallic glasses in the supercooled liquid region. First, supercooled liquids are metastable and have a tendency to crystallize, so there is a limited window of time (typically on the order of minutes) in which the processing must be completed if the glassy structure is to be maintained. Second, the viscosity of many glass-forming alloys near the glass transition temperature is too high for convenient processing. The viscosity can be reduced by increasing the processing temperature, but higher temperatures promote crystallization 1 A crystalline metal, In contrast, melts abruptly, going from a rigid solid to a low-viscosity fluid very quickly. 4 UNCLASSIFIED/ /FOA OJifilCIOP 1155 ON! X
Not linked to a story yet.
Official release, from the pursue collection. The PDF is mirrored here; the original link is above. 30 pages are in the text index: search them above, or from the library's search.