Documents / Report
The Roswell Report: Fact vs. Fiction in the New Mexico Desert
USAF / The Black Vault · 1995 · 882 pages · text by OCR
The Roswell Report: Fact versus Fiction in the New Mexico Desert was published by Headquarters United States Air Force in 1995. The Black Vault distributes this copy. It reproduces the report by Col. Richard L. Weaver and the synopsis by 1st Lt. James McAndrew, both written after a General Accounting Office inquiry requested by Representative Steven Schiff. The Air Force search found no evidence of an extraterrestrial craft or crew. It concluded that the Roswell debris most likely came from NYU Flight No. 4, a Project MOGUL balloon train.
“Sea”23 pages
- p. 193 …overhead and followed the balloons out to sea. I have no idea about the results that…
- p. 200 …the regular 334 that we had at sea level. From that they could deduce the temperature…
- p. 243 …actually located on the jurisdictional lines between Sea Girt and Springlake, New Jersey. It was an…
- p. 244 …The Sea Girt Inn?
A: Exactly. That's where John had his office, and I was…
- p. 320 …alone is about 24,000 miles at sea level, and about 4500 miles at 45,000…
- p. 325 …twenty-five (25) feet at their largest sea-level diameter. The sonic unit was a combination…
- p. 378 …per hour when one-fifth inflated at sea level).
One other type of balloon which has…
- p. 402 …Let us, then, compare the rate of leakage at any given altitude with leakage at sea…
- p. 404 …The leakage at any altitude may be expressed as a function of leakage at sea level…
- p. 405 Comparing rate of leakage at 40,000 feet with leakage at sea level:
$$
\frac {L _ {4…
- p. 407 …If a 20-foot diameter balloon $ \frac{1}{1 0} $ full were tested at sea level…
- p. 408 …At sea level this is equivalent to 5.32 gm/hr. for a 20-foot diameter…
- p. 414 …Using the rules of subsonic aerodynamics, Picard suggests that air at sea level escaping at 1333…
- p. 415 …air at sea level (lb./ft. $ ^{3} $ )
14.7 = pressure of air at sea level (psi…
- p. 432 …to about 20 millibars and increased to sea-level pressure at different temperatures.
The most comprehensive…
- p. 563 …The height above mean sea level as determined from pressure measurements used in this work with…
- p. 644 …point at which the radiosonde reaches the sea surface.
## 2. Earlier attempts
There have been numerous…
- p. 645 …The balloons floated between the surface and 30,000 ft above sea level; those which reached…
- p. 704 …Met Gifford who has 90' sea rescue boat this project is planning to use. Stayed at…
- p. 719 …Worzel working on gravity at sea. Saw Geo Woollard and the Ryders. Woollard after Guggenheim fellowship…
- p. 779 …the launching site is markedly different from sea level, a shift in this curve is needed…
- p. 817 …balloon at all times with respect to sea level. On this curve also it is customary…
- p. 825 …The height above mean sea level as determined from pressure measurements used in this work with…
signals may be arranged so as to consume a very small portion of transmission time.
D. The duration of radio reception and of positioning data may be greatly extended by appropriately equipped aircraft. It is intended to utilize a B-17 with top-mounted radar to search above the plane for tracking. Depending upon the noise-level encountered, it may be possible to acquire pressure data with a receiver in the plane. It may be necessary to provide at least two aircraft for continuous reception over long periods.
2. It is very desirable that the simplified light-weight ballast control system for flights of less than 24 hours' duration be perfected. The elaborate ballast assembly with the automatic ballast valve will not be needed for the many contemplated flights which will be made with a useful life of less than eight hours. A lower-capacity reservoir with manual ballast valve and filter provides a light-weight, inexpensive unit. Tests are now being conducted to find the best design for these components.
3. In order to float a balloon at a pre-selected maximum altitude it is necessary to supplement the variation-of-ballast with a new height control system.
A. With a given balloon, and given total load, it is possible to forecast the maximum height. (See Section III for the computation.) If various maximum heights are desired, this maximum height may be varied by varying the total load, or varying the bouyancy of the balloon through variation in balloon volume.
About this file
Report, cited by the archive. The PDF is mirrored here; the original link is under it. The text was read from the page images by an OCR model; expect the odd misread word. 882 pages are in the text index: search them above, or from the library's search.