Documents / Report

The Roswell Report: Fact vs. Fiction in the New Mexico Desert

USAF / The Black Vault · 1995 · 882 pages · text by OCR

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published by Headquarters United States Air Force in 1995. The Black Vault distributes this copy. It reproduces the report by Col. Richard L. Weaver and the synopsis by 1st Lt. James McAndrew, both written after a General Accounting Office inquiry requested by Representative Steven Schiff. The Air Force search found no evidence of an extraterrestrial craft or crew. It concluded that the Roswell debris most likely came from NYU Flight No. 4, a Project MOGUL balloon train.

  • p. 193 …overhead and followed the balloons out to sea. I have no idea about the results that…
  • p. 200 …the regular 334 that we had at sea level. From that they could deduce the temperature…
  • p. 243 …actually located on the jurisdictional lines between Sea Girt and Springlake, New Jersey. It was an…
  • p. 244 …The Sea Girt Inn? A: Exactly. That's where John had his office, and I was…
  • p. 320 …alone is about 24,000 miles at sea level, and about 4500 miles at 45,000…
  • p. 325 …twenty-five (25) feet at their largest sea-level diameter. The sonic unit was a combination…
  • p. 378 …per hour when one-fifth inflated at sea level). One other type of balloon which has…
  • p. 402 …Let us, then, compare the rate of leakage at any given altitude with leakage at sea…
  • p. 404 …The leakage at any altitude may be expressed as a function of leakage at sea level…
  • p. 405 Comparing rate of leakage at 40,000 feet with leakage at sea level: $$ \frac {L _ {4…
  • p. 407 …If a 20-foot diameter balloon $ \frac{1}{1 0} $ full were tested at sea level…
  • p. 408 …At sea level this is equivalent to 5.32 gm/hr. for a 20-foot diameter…
  • p. 414 …Using the rules of subsonic aerodynamics, Picard suggests that air at sea level escaping at 1333…
  • p. 415 …air at sea level (lb./ft. $ ^{3} $ ) 14.7 = pressure of air at sea level (psi…
  • p. 432 …to about 20 millibars and increased to sea-level pressure at different temperatures. The most comprehensive…
  • p. 563 …The height above mean sea level as determined from pressure measurements used in this work with…
  • p. 644 …point at which the radiosonde reaches the sea surface. ## 2. Earlier attempts There have been numerous…
  • p. 645 …The balloons floated between the surface and 30,000 ft above sea level; those which reached…
  • p. 704 …Met Gifford who has 90' sea rescue boat this project is planning to use. Stayed at…
  • p. 719 …Worzel working on gravity at sea. Saw Geo Woollard and the Ryders. Woollard after Guggenheim fellowship…
  • p. 779 …the launching site is markedly different from sea level, a shift in this curve is needed…
  • p. 817 …balloon at all times with respect to sea level. On this curve also it is customary…
  • p. 825 …The height above mean sea level as determined from pressure measurements used in this work with…
sufficiently to cause a short between the electrodes, firing the squib prematurely. If the distance is too large, however, there will be too great a height difference between the time of minimum pressure and the time the electrodes are shorted. For instance, a spacing of 10 mm. would delay the firing of the squib until the pressure reached 13.3 mb. above the minimum pressure. At an altitude of 50,000 feet, the equivalent height (standard atmosphere) would be about 2300 feet. It is obvious that for high level flights, a less dense and lower freezing electrolyte for the minimum pressure switch will be needed to obtain the desired sensitivity of 2000 feet.

By adding the pressure-activated automatic ballast valve to the manual ballast valve, the complete pattern of the solid curve in Figure 7 may be achieved ideally. At sunset the rapid cooling causes descent which cannot be compensated for by the manual ballast valve. As soon as the seal-off pressure of the automatic ballast valve is exceeded by the atmospheric pressure, ballast flow is begun, which restores the balloon to its ceiling.

The dashed curve in Figure 7 shows the action of a balloon when the automatic ballast valve alone is used for control purposes. In this case the balloon will sink slowly from its ceiling (where full buoyancy just equals the load) to the level where the automatic ballast valve drops ballast at a rate equal to the diffusion (the floor). It will be noted that a flight which is controlled in this manner is less wasteful of ballast and results in a correspondingly longer flight. The "floor" determined by this valve varies diurnally as the temperature (hence pressure) of the air entrapped in the diaphragm is affected by solar radiation. The amplitude of this diurnal oscillation may be as much as 6000 feet, the night level being higher than the day level.

Cited by

Cases discussed

About this file

Report, cited by the archive. The PDF is mirrored here; the original link is under it. The text was read from the page images by an OCR model; expect the odd misread word. 882 pages are in the text index: search them above, or from the library's search.