“Gross”27 pages
- p. 118 …Robert Gross and Mr. Maher of Lockheed
11:55 A.M. Gen. Sam Anderson
12:00…
- p. 393 …in the form of an altitude vs. gross load chart with helium as the lifting gas…
- p. 394 …4}{\text {Gross Load}} = \frac {K}{W}
$$
In turn, $ \frac{K}{W}=a e^{-0. 4…
- p. 395 …free lift in pounds and G is gross lift in pounds.
Although this equation was derived…
- p. 400 …By equation (10), with a gross load of 52 kg., the unbalance caused by loss of…
- p. 412 …or a gross buoyancy of 450 lb., the maximum allowable inflation of a 30' diameter, .001…
- p. 479 …accelerating force equal to 5% of the gross load (52 kg) was acting to bring the…
- p. 552 …000 feet.
In one step, this becomes:
Gross Lift/Balloon = (Balloon Volume) x (Difference in molecular…
- p. 555 …of rise in feet per minute
G = gross lift in grams
For our purposes, we wish…
- p. 559 …G) ^ {\frac {2}{3}}
$$
(Approximate)
where G = gross load
A chart, Figure 24, has beendrawn up…
- p. 561 …where $ \triangle G= $ loss of lift
G = gross load (balloon weight plus equipment load)
$ \triangle T…
- p. 562 …not including balloon or its integral parts.
Gross load: Load on the gas at release (Balloon…
- p. 635 …Serial No. ___
description ___ ___
Line length ___
Banner description ___ ___
Ballast assembly - description ___ ___
Eallast. ___
Total Equipment Weight. ___
Gross Load ___
- p. 636 …Gross Load . . . ___
Assumed Gross Lift (Gross Load + 10%) G ___
G 2/3 ___
Free Lift - F = $ (\frac…
- p. 649 …theoretical altitude determined by the displacement and gross load.
## 7. Control systems
Two systems of control…
- p. 681 …By adjusting the gross load to be supported by the gas to equal the total lift…
- p. 691 …A chart showing the relation between altitude, gross lift, and balloon size has been found necessary…
- p. 775 …The gross load reported should be accurate to the nearest 200 grams. The amount of lifting…
- p. 777 500 gm DRAG CHUTES
300 " BANNER
2000 " PAYLOAD
4500 " BALLOON
7300 " GROSS LOAD
## NOTE:
Use low…
- p. 779 …bubble length and resultant inflated volume, using gross lift as an expression of volume. It will…
- p. 781 …in Appendix II summarizes the relationship between gross load and floating level for balloons of several…
- p. 817 …A can of sand is made to weigh the same amount as the required gross lift…
- p. 825 …the balloon with the equipment load attached.
Gross Lift: Lift of all of the gas in…
- p. 830 …Serial No. ___
description ___
Drag chute ___ ___
Banner description ___ ___
Ballast assembly - description ___ ___
Ballast ___
Total Equipment Weight . ___
Gross Load . . . . . . . . . . . . . . . . ___
- p. 831 …waiting___ grams
Actual balloon lift . . . . . . . . . . . ___ "
AActual gross lift (Balloon lift & balloon wt.) . . . . . ___ "
Number Helium tanks required…
- p. 835 …Gross Lift vs. Bubble Length . . . . . . . 107
Graph 3: Buoyancy vs. Altitude . . . . . . . . . . 108
Graph 4: Gross Load…
- p. 847 …Estimated Gross Load Limit kg. Altitude Range ft.
7 200 0.6 1.5 to 5…
Flight 75: Released from Alamogordo, New Mexico, 1010 MST, July 20, 1948 Recovered at Hollister, California
In order to reach higher altitudes than was possible when 20-foot plastic balloons were used, a 70-foot, .001" polyethylene cell was flown on Flight 75. To determine the duration of buoyancy of this type of balloon no controls were used. Despite this, the balloon remained aloft for more than 60 hours and successfully withstood the loss of superheat occasioned by at least two sunsets. From the height-time curve of this flight (Figure 29) the very marked effect of superheat is apparent.
TIME-MST
Figure 29
The record of the barograph was not complete since the clock stopped each night (clearly recording the lowest elevation reached, however) and ran down completely after 56 hours.
Since the small external appendix with cardboard stiffeners was not suitable for the large balloon, a new design with aluminum formed stiffeners (Figure 30) was used. This type of appendix closer worked well on later flights, and it is likely that the long duration of this flight may be attributed in part to satisfactory closing off of the aperture. In addition to