“Headquarters”32 pages
- p. 3 # THE ROSWELL REPORT
# Fact versus Fiction in the New Mexico Desert
Headquarters United States Air Force…
- p. 8 Clinical Investigations and Life Sciences Division, Headquarters Air Force Medical Operating Agency, Bolling AFB, DC; John…
- p. 25 …the disc had been "flown to higher headquarters." That same story also reported that a Roswell…
- p. 27 …These locations include Fort Worth, Texas, the home of the Eighth Air Force Headquarters; possibly Sandia…
- p. 61 # DEPARTMENT OF THE AIR FORCE HEADQUARTERS UNITED STATES AIR FORCE
MEMORANDUM FOR SAF/AA
FROM: AF…
- p. 65 …DuBose says officials at the Headquarters of the Eighth Air Force were directed to tell the…
- p. 70 # DEPARTMENT OF THE AIR FORCE HEADQUARTERS UNITED STATES AIR FORCE WASHINGTON DC
MEMORANDUM FOR SAF/AAZ…
- p. 86 HEADQUARTERS
509TH BOMB GP (VH)
ROSSELL AFFY AIR FIELD
ROSSELL, NEW MEXICO
GENERAL ORDERS)
NUMBER 9…
- p. 87 …Arner per Paragraph 3, Special Order, #139, Headquarters, Roswell Army Air Field, dated 18 July 1947…
- p. 89 …Arner per paragraph 3, SO #139, Headquarters, this station, dated 18 July 1947. 1st Lt. Lewis…
- p. 90 …Colonel Loberg, Headquarters, Eighth Air Force, arrived this date to coordinate with S-3 and check…
- p. 91 …Boatright, Headquarters, Eighth Air Force, arrived to coordinate with Statistical Control on cost analysis.
16 July…
- p. 110 # HEADQUARTERS, ARMY AIR FORCES WASHINGTON
SUBJECT: Issuance of Orders
## TO:
NND760168
Commanding General Air Material Command…
- p. 119 …where we haven't squadron or group headquarters should take their people away.
1:55 P…
- p. 131 …I did not make a report of this incident to my headquarters since I felt that…
- p. 136 …700 CIC was the CIC Headquarters.
- p. 137 …700 CIC was the Headquarters?
SC: Yes, I don't think I even made a report…
- p. 138 …I think this was taken at the Headquarters at Carswell.
RW: Yeah, that's right. That…
- p. 139 …I took it to 8th Air Force Headquarters, General Ramey was excited; they were going to…
- p. 148 …I don't even want 700 CIC Headquarters to know we wasted our time on it…
- p. 149 …And if anybody from headquarters CIC came in I'm positive they would have checked in…
- p. 192 …I was assigned, believe it or not, to Headquarters, Air Force... I still have the Headquarters…
- p. 230 …on the basis of orders out of Headquarters Army Air Force.
Q: While you were operating…
- p. 231 …These are the pictures taken in General Ramey's office, 8th Air Force Headquarters by a…
- p. 246 …Then after I left the headquarters of ARDC in Baltimore, I spent four years at the…
- p. 269 …debris be flown to Eighth Air Force Headquarters at Fort Worth AAF, TX, for his personal…
- p. 278 …Andrews AAF was headquarters of the Army Air Forces Weather Service. It is also interesting to…
- p. 306 …this local headquarters of the AMC under the Walton Laboratories group, who have headquarters at Red…
- p. 325 HEADQUARTERS FITZWILLIAM FORWARD c/o Commander, Task Group 7.2 APO 187, c/o Postmaster San…
- p. 327 …Reports of results were made to Headquarters FITZWILLIAM FORWARD and to AFMSW-1.
Results of the…
- p. 855 …Brady, all from Headquarters. Eighth Air Force, arrived here for a conference and inspecting and coordination…
- p. 873 …Marcellus Duffy eliminated it and several others from the project when Headquarters U.S. Army Air…
A glass flask is open to atmospheric pressure through a fine capillary tube. With various rates of change of pressure, various differential pressures exist between the air in the flask and the outside air. This pressure difference controls the level of liquid in a manometer switch, filled with 24% hydrochloric acid. When the internal pressure is 0.2 mb more than the ambient pressure, the switch opens and ballast flow is stopped even though the balloon may be below the floating level. (The switch is set so that a rate of change of .1 mb/minute acting for three or more minutes will open the switch.) By thus restricting flow when the balloon is rising, balloon oscillations are minimized and ballast is conserved. A sketch of this operation is shown as Figure 13.
Figure 13. Height-time curve, showing ballast control action.
Since the rate switch is much more delicate than the displacement switch, safety considerations have caused the combined control to be supplemented by a pure displacement switch control. In this, the conducting segment of the pressure modulator is divided, and only a limited pressure height range (set for desired floating level) is controlled by both switches in series. If the rate switch is damaged at launching (by spilling some of its electrolyte, for instance) or in flight (perhaps by evaporation of the electrolyte) and the balloon descends, simple displacement control becomes effect when the high pressure lower altitude) segment of the conductor is touched by the pres-