Documents / Report

The Roswell Report: Fact vs. Fiction in the New Mexico Desert

USAF / The Black Vault · 1995 · 882 pages · text by OCR

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published by Headquarters United States Air Force in 1995. The Black Vault distributes this copy. It reproduces the report by Col. Richard L. Weaver and the synopsis by 1st Lt. James McAndrew, both written after a General Accounting Office inquiry requested by Representative Steven Schiff. The Air Force search found no evidence of an extraterrestrial craft or crew. It concluded that the Roswell debris most likely came from NYU Flight No. 4, a Project MOGUL balloon train.

  • p. 12 …Fort Worth Star-Telegram, Photographs of Balloon Debris, July 9, 1947 17. Statement, Lt. Col. Sheridan…
  • p. 13 …Fort Worth Star-Telegram, Photographs of Balloon Debris, July 9, 1947 2. Organizational Chart, Watson Laboratories…
  • p. 27 …These locations include Fort Worth, Texas, the home of the Eighth Air Force Headquarters; possibly Sandia…
  • p. 31 …DC; Federal Records Center, Ft Worth, TX; the INSCOM Archives, Fort Meade, MD; National Air and…
  • p. 35 …in the famous photos (Atch 16) in Fort Worth was that of a radar target normally…
  • p. 36 …were told was a flying saucer to Fort Worth. The people on board included...and Maj…
  • p. 37 …Newton was a weather officer assigned to Fort Worth, who was on duty when the Roswell…
  • p. 42 …photographs taken at the time by the Fort Worth Star-Telegram, that depicted Ramey and Marcel…
  • p. 43 …the wreckage prior to its getting to Fort Worth. This organization reported on July 20, 1994…
  • p. 47 …After the autopsies, conspiracy theorists said the bodies were flown to Fort Worth and then to…
  • p. 65 …to Fort Worth. "Flying disc." Some of the debris was flown to Fort Worth. as where…
  • p. 84 …Center (WNRC) or the Southwest Regional Depository (Fort Worth, Texas). ## Recommendations Because the records management policy…
  • p. 131 …taken to Eighth Air Force Headquarters in Fort Worth where it was subsequently identified as a…
  • p. 138 …And I obviously...Marcel took it to Fort Worth. Yeah that's the... RW: Yeah. That…
  • p. 139 …into Wright-Pat and Kirtland, or to Fort Worth. Back and forth, loaded up, with very…
  • p. 145 …Then it said: "After Marcel had gone to Fort Worth and came back Marcel challenged the…
  • p. 147 …O.K."Marcel would take some of the sample to Fort Worth to show Ramey. In…
  • p. 150 normal course of his duty was sent to Washington not 8th Air Force in Fort Worth…
  • p. 219 …But the Roswell morning paper clearly showed that there was a knowledgeable person in Fort Worth…
  • p. 231 …Headquarters by a news photographer of the Fort Worth Star Telegram. It's four pictures that…
  • p. 263 …I was the only weather forecaster on duty in the Fort Worth base weather and flight…
  • p. 269 …flown to Eighth Air Force Headquarters at Fort Worth AAF, TX, for his personal inspection. Upon…
  • p. 277 …Before the announcement was made, the "disc" was flown to Fort Worth AAF, at the direction…
  • p. 278 …giant thermos jug" was allegedly transported from Fort Worth AAF to Wright Field. $ ^{38} $ This description…
  • p. 280 designs on it." $ ^{41} $ Furthermore, the Fort Worth Army Airfield Weather Officer, Irving Newton, who was…
  • p. 283 1 Fort Worth Star-Telegram Photographs of Balloon Debris July 9, 1947
  • p. 549 …Similarly, the Fort Worth Sub-Committee established a procedure for flights made within the Fort Worth…
  • p. 616 …Air Coordinating Committee, Fort Worth Regional Airspace Subcommittee. Subject: Obstructions to air navigation...43 5. Memorandum…
  • p. 655 …5/15/47 Office of the Secretary Fort Worth Sub-Committee on Air Space Civil Aeronautics…
  • p. 715 …Arrived in Fort Worth about 9 EDST. Off again to Big Springs, Texas, where forced to…
Output of the oscillator is both amplitude and frequency modulated, the amplitude modulation being limited by a class "C" RF amplifier. This unit weighed six ounces, was fed by a plate voltage of 270 volts with a filament drain of 400ma. at 1.5 volts. The output was one watt at frequencies from 25 to 100mc.

Before procurement of a receiver with automatic frequency control an attempt was made to develop a crystal controlled oscillator to overcome the frequency drift inherent in FM systems. This work was abandoned when the controlled receiver was obtained. The crystal control unit which was developed required extreme care in tuning in order that modulation be linear.

A miniature power amplifier, using one dual triode as a push-pull amplifier was constructed for use at 25 to 100mc with any of the above mentioned transmitters. The antennae for these transmitters was a half-wave vertical dipole.

The receiver found satisfactory for these systems was the R-2A/ARR-3 Sonobuoy receiver. This unit employs Automatic frequency control and will tolerate a drift $ - .35mc $ before retuning is required.

When SCR-658 radio direction finding equipment became available work on these transmitters was abandoned and a 400mc transmitter used. This system allows for accurate positioning of the balloon systems by use of crossed azemuths from several receiving stations.

A transmitter using pulse time modulation was designed for use with this receiving equipment. The advantages here are high peak power with relatively low input power (and thus a high signal to noise ratio) and simultaneous transmission of several data channels at one frequency. This project was abandoned before tests could be completed due to a modification of project requirements, but preliminary results indicated that this system would be advantageous in AM or FM transmission. This system makes use of short duration pulses ( .5 micro second) at a repetition rate of approximately 10 kc.

For long range transmission of information an amplitude-modulated transmitter was developed. (Fig. 6) This unit, the AM-1, is crystal controlled, employing a 3A4 miniature tube in a Pierce oscillator circuit as the crystal oscillator. This circuit does not require an LC tank circuit and eliminates the tuning of this additional stage. The RF amplifier is a 3A5 miniature dual triode tube. The unit was designed to give 1.5 watt output with a 270 volt plate supply and can be used with 380 volts to give 3 watt output.

Cited by

Cases discussed

About this file

Report, cited by the archive. The PDF is mirrored here; the original link is under it. The text was read from the page images by an OCR model; expect the odd misread word. 882 pages are in the text index: search them above, or from the library's search.