Documents / Report

Department of the Air Force Report, 1996

U.S. Department of War · 1996-09-10 · 181 pages · text from the file's own layer

This final report, dated September 10, 1996, was prepared by the Research Triangle Institute for the Department of the Air Force's 45th and 30th Space Wing safety offices. Titled Modeling Unlikely Space-Booster Failures in Risk Calculations, it shows how rare Mode-5 failures, in which a rocket veers well off its intended flight line, are modeled in the DAMP risk-analysis program. An appendix lists Atlas, Delta, Titan and Thor launch and failure histories through August 1996.

From the source:Release of 2026-05-08 Incident: 9/10/96, N/A. This report describes the Modeling of Unlikely Space-Booster Failures in Risk Calculations, documenting historical launch failure modes and recommending corrective actions to address them using novel modelling techniques.

response. Referring to Eq. (3), the right-hand member must be multiplied by the
probability p5 of a Mode-5 response to obtain absolute probabilities. Except for TB
itself (and to a slight degree, shaping constants A and B), the quantities in the
equation do not depend on TB. Thus if TB and p5 are both changed so that p/(TB -
Tp) remains constant, the computed risks are unchanged.
If destruct action (i.e., impact limit lines) is included in the DAMP calculations,
the supplemental risks* resulting from that action must be accounted for. In this
case, the termination time has a minor influence on results, since it affects the
number of impacts that would occur beyond the impact limit lines without
destruct that are forced inside when destruct action is taken. If destruct action is
omitted, the value of TB is immaterial (i.e., supplemental Mode-5 risks are non-
existent) provided that the impact range along the reference trajectory at time TB
exceeds the range to all targets of interest. (Except in this paragraph,
supplemental Mode-5 risks are not addressed in this present report.)
d. Vacuum calculations: Atmospheric effects were accounted for in determining
when vehicle breakup would occur and, to some extent, during each thrusting
tum by using accelerations from the nominal trajectory. To reduce computer time
and cost of this study, vacuum calculations were made during free fall after
vehicle breakup or burnout. Although this increased impact dispersions
somewhat, vacuum results should not be drastically different from those
obtainable using a maximum-beta piece. In theory at least, different mode-5
shaping constants exist for each debris class. In view of the uncertainties in
vehicle breakup conditions and characteristics, and in the overall process of
• simulating Mode-5 malfunctions, attempts to derive unique shaping constants for
each debris class did not seem justified.
6.1.4 Malfunction-Turn Results for Atlas IIAS
For Atlas IIAS, .the distribution of impacts for simulated random-attitude turns, slow
turns, and a weighted combination (75% random-attitude and 25% slow tum) are
shown in Figure 5. Since the impact distribution (i.e., the percentages of impacts in 5°
sectors) for the weighted composite was not significantly different from that for
random-attitude failures, slow-turn computations were not made for Delta, Titan, and
LLVl.
* See Ref. [1], Section 10.
9/10/96 35 RTI

Not linked to a story yet.

About this file

Report, from the pursue collection. The PDF is mirrored here; the original link is above. 181 pages are in the text index: search them above, or from the library's search.