Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

  • p. 129 …6099 2 HQ AMC WRIGHT PAT 342-seA-6191 CAMBRIDGE LABS 342-A~ AMC HQ WRIGHT…
  • p. 228 …overhead and followed the balloons out to sea. I have no idea about the results that…
  • p. 235 …the regular 334 that we had at sea level. From that they could deduce the temperature…
  • p. 279 …actually located on the jurisdictional lines between Sea Girt and Springlake, New Jersey. It was an…
  • p. 280 …The Sea Girt Inn? A: Exactly. That's where John had his office, and I was…
  • p. 400 …alone 1a about 24,000.m1lea at sea level, aDd about '500 allea at 45,000…
  • p. 407 …five (25) feet at their ls.rgest sea-level diameter. The sonic unit was a combination…
  • p. 466 …hour when one-fifth inf~ated at sea level). One other type of balloon which has…
  • p. 490 …Let us, then, compare the rate of leakage at any given altitude with leakage at sea…
  • p. 492 …The leakage at any altitude may be expressed as a function of leakage at sea level…
  • p. 493 Comparing rete of leakage at 40,000 feet with leakage at sea level: ~ 188 .u§. - 0…
  • p. 495 …It a 20-foot diameter balloon~ full were tested at 10 sea level and found to…
  • p. 496 …At sea level this is equivalent to 5.32 ~r. for a 20-foot diameter balloon…
  • p. 502 …Using the rules of subsonic aerodynamics, Picard suggests that air at sea level escaping at 1333…
  • p. 503 …sea level (psi) escape velocity of air to produce back pressure of 1 atmosphere at sea…
  • p. 520 …to about 20 millibars and increased to sea-level pressure at different temperatures. The most comprehensive…
  • p. 654 …The height above mean sea level as determined fram pressure measurements used in this work with…
  • p. 686 …to a thtmble a.nd attached to re1n forced pCltches at alterna.te .sea.m.s…
  • p. 688 …lQr9e Ba.lloo n ~hould trQin de .sea nd to 101000'. 6 each.-Gene ral M1lls…
  • p. 736 …point at which the radiosonde reaches the sea surface. 2. Earlier attempts There have been numerous…
  • p. 737 …The balloons floated between the surface and 30,000 ft above sea level; those which reached…
  • p. 801 …Vet Gifford ;.;ho has 0 0' sea rescue boat this project is planning to use. Stayed…
  • p. 816 …Worzel working on gravity at sea. Saw Geo Woollard and the Ryders. Woollard after Guggenheim fellowship…
  • p. 887 …the launching site is markedly different from sea level, a shift in this curve is needed…
  • p. 925 …balloon at all times with respect to sea level. On this curve also it is customary…
  • p. 933 …The height above ~ean sea level as determined from pressure measurements used in this work with…
1020 millibars) against. percentage of the turns
as read on the nomogram. The lowest pressure
reading is numbered as read and succeeding
pressures are plotted in a continuous ascending
series. When the pressure reading reached the
first_overlap on the reference, it is called
100 percent; the second overlap is 200 percent
and so on until the last overlap which may be
1200 or 1300 percent.
(c) Pack the modulator and insert it inside the
transmitter box. The modulator should be pro-
tected from extreme cold since the motor opera-
tion becomes erratic when the temperature reached
:soo to 400C below zero. A box or paper cover
over the modulator will keep particles of in-
sulation and dirt from the moving parts.
(d) When the entire assembly has been made and in-
flation of the balloon is about to begin, the
transmitter and motor should be turned on and
reception of the signal tested. If any serious
trouble appears, the modulator should be re-
placed by another calibrated modulator since
any work on the instrument will probably change
the calibration.
During the flight,radio static and noise will
appear on the Brush record as pips which may re-
semble the transmitted signals and with increasing
distance or weakening transmitter the noise will
finally completely obscure the pressure record.
Careful tuning of the receiver will prolong
the record as long as possible. When tuning
the receiver, the sensitivity control of the
Brush amplifier should be turned to the least sen-
sitive position since any sudden change in the
tuning may throw the pen off its supports and
damage its glass tip.
'When the flight reception is completed the re-
cord is evaluated exactly as in the evaluation
of the calibration record--using the same nomo-
gram. However, since the instrument is subjected
to different atmospheric condition~, the motor
speed may vary suddenly, giving false values for
the pressure. These values may be detected by
carefully observing the rate of rotation of the
motor, which is measurable by the distance be-
tween the reference marks. If there is a sudden
-61-

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.