Documents / FOIA release
The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.
“Blanchard”20 pages
is riot useful when the changes occur at a nearly con- stant altitude due to the width of the steps and the am- biguity of di'rection of vertical motion. Two pressure measuring systems have been found satisfactory for use in constant-level work and are discussed below. For a discussion of the radio transmitters which have been used (the standard T-69 and,the NYU AM-1), see Techni- cal Report No. 2, Balloon Project, New York University Research Division. (1) Olland Cycle Pressure Measuring Instrument This instrument, shown in Figure 31, is used in balloon flights as the primary pressure measuring unit, as it will continuously measure pressure without ambiguity. It modulates the transmitted r"dio signal at intervals whose timing is determined by the pressure of the air at the balloon's position. As presently designed, the modulator contains a standard Signal Corps ML-310E radiosonde aneroid unit, a rotating cyclinder of insulating material with a metal helix wound around the cylinder, and a 6-volt electric motor which rotates the cylinder. There are two contacting pens which ride on the cy- linder and conduct electrical current when they touch the helix. One pen is fixed in position and makes a contact at the same time in each revolution of the helix. This contact is used as a reference point for measuring the speed of rotation of the cylinder. The time that the second one, which is linked directly to the aneroid cell, makes contact with the spiral, is dependent on the cylinder speeed and on the pen position which is detennined by the pressure. By an evaluation chart, the atmospheric pressure can be detennined as a function of the relative posi~ion of the pressure contact as compared to the reference thus eliminating ell rotation effect$ but short term motor speed fluctuations. Preparation of the modulator for flight consists of the following steps: (a) Test the motor operation. When a 6-volt battery is inserted in the motor circuit with the proper polarity, the motor should run smoothly at one re~olution per 60 to 80 seconds. Noisy opera- tion is probably a sign of dirty or corroded -54-
FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.