Documents / FOIA release
The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.
“Fort Worth”32 pages
weight of equipment and balloon, the distribution of density in the atmosphere and the buoyancy of the lifting gas. Assuming that the lifting gas is helium, Graph 3 in Appendix II summarizes the relationship between gross load and floating level for balloons of several diameters. To use this graph t·o .find the floating level of a balloon of given size and load, enter with the required buoyancy (equal to the gross load). Go vertically to the diagonal line corresponding to the balloon size and then horizontally to the extreme left-hand edge and read the altitude. The volume of the balloon is related to density by the use of the molar volume in this chart. Assuming observed pressure and temperature distributions over selected stations and theN. A. C. A. standard atmosphere, the molar volume is given as well as the altitudes. Table 1 of Appendixii gives theN. A. c. A. Standard Atmosphere relating pressure with altitude, and Table 2 gives the variation of temperature with altitude. For local condi- tions more exact measurements may be made using the temperature ana pressure distribution indicated by a sounding rather than the standard. To do this, it is necessary to compute the molar volume from this relationship molar volumez= 359 ft. 3 x ~ x 1013.3 mb 2730C Pz Example: Find the molar volume at 30,000 feet MSL where the reported temperature is -30°C, and the reported pressure is 300 mb. molar volume30 , 000 = 359 ft.3 X (273-30fc X 1013 mb, - 1080 ft. 3 2730C 300mb. This is the volume of a pound mol of any gas at those condi- tions. By plotting several points of this curve of molar volume. versus altitude, it is possible to locate very exactly the altitude which corresponds to the molar volume to which the balloon will go (found from Graph 3 or as follows), This density or molar volume to which a balloon will rise is given by the following formula: Molar volume •Balloon volume Gas Lift/mol Gro•• load Gas lift/mol= 11.1 kg/mol(using Helium) -35-
FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.