Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

  • p. 143 …Robert Gross ar.d 't!r. Jlaher of Lockheed 11~ 55 A.'.!. Gen. Sam Anderson 12…
  • p. 481 …Balloon Volume x Gas Lift Gross Load · It may be noted from this equation that a…
  • p. 482 …Balloon Volume x 24.4 Gross Load K =-w K _ 08.o475Z In turn, w-in…
  • p. 483 …free lift in pounds and G is gross lift in pounds. Although this equation was derived…
  • p. 488 …By equation {10), with a gross load of 52 kg., the unbalance caused by loss of…
  • p. 500 …or a gross buoyancy of 450 lb. • the maximum allowable infle.tion of a 30' diameter…
  • p. 569 …accelerating force equal to 5% of the gross load (52 kg) was acting to bring the…
  • p. 643 …000 feet. In one step, this becomes: Gross Lift/Balloon = (Balloon Volume) x (Difference in molecular…
  • p. 650 (Approximate) where G • gross load A chart, Figure 24, has beendrawn up, based on this equation…
  • p. 652 …G = loss of lift G =gross load (balloon weight plus equipment load) AT : mean temperature difference…
  • p. 653 …not including balloon or its integral parts. Gross load: Load on the gas at release (Balloon…
  • p. 726 …Ballast • • .. • • '" • Total Equipment l~eight. • • • • ' Gross Load • • ' • • • • {56)
  • p. 727 …Balloon volwne x gas litt/mol gross load cu. ft. -----------------NAximum Altitude • • • ft, m.s.l…
  • p. 741 …altitude deter- mined by the displacement and gross load. 7. Control systems Two systems of control…
  • p. 777 …By adjusting th~ gross load to be supported by the gas to equal the total lift…
  • p. 787 …Computations A chart showi~ the relation between altitude, gross lift, and balloon size has been found…
  • p. 883 …The gross load reported should be accurate to the nearest 200 grams. The amount of lifting…
  • p. 885 …A L L 0 0 N 7300 ,, GRoss LoAD Fl G. 17 NYU BALLOON pROJECT I…
  • p. 887 …bubble length and resultant inflated volume, using gross lift as an expression of volume. It will…
  • p. 889 …in Appendix II summarizes the relationship between gross load and floating level for balloons of several…
  • p. 925 …A can of sand is made to weigh the same amount as the required gross lift…
  • p. 933 …the balloon with the equipment load attached. Gross Lift: Lift of all of the gas in…
  • p. 938 …description.______________ Drag chute ---------------------------- Banner description --------------- ---------- Ballast assembly - description -----------~-- Ballast • • • • • • Total Equipment i'ieight • • ' • • • • • • Gross Load • • • • • • • • • • • -86-
  • p. 939 …wnitin_,g________ grams Actual balloon lift • • • • • • • • ". . .• II AActunl gross lift (Balloon lift & balloon wt.) • Number Helium…
  • p. 943 …Gross Lift vs. Bubble Length • • • • • • .107 Graph 3: Buoyancy vs. Altitude • • • • • • • • • .108 Graph 4: Gross Load…
  • p. 955 …BALLOOO DA 'fA General Mills Actual Balloon Estimated Gross Altitude ~ominal Diiameter Volwne Weight Load Limit…
volume of the 20-foot cell is about 4300 cubic feet and
its uninflated length is 38 feet. It is made up of 20
gores, heat sealed together in a butt weld. Along the
seams thus formed, a special acetate-£iber scotch type
tape (Minnesota Mining and Mfg. Co.,) is laid to reinforce
the weld and to carry and distribute the load. These
tapes converge to an appendix ring at the balloon bottom,
to which the load harness is attached. By using this
stressed tape design, much larger loads may be carried than
the thin polyethylene alone could hold. To exclude
air entering through the bottom, which is left open, an
external skirt or appendix is added.
Figure l Shows a 20-toot balloon ready to be released,
with an external appendix in position. As the balloon
rises, the lifting gas inside will expand until the balloon
is full, whereupon the excess gas which was needed to
make the balloon rise will be valved out. The full bal-
loon will then float at a level where the buoyancy just
balances the load. It will remain there until buoyancy
is lost by diffusion of the lifting gas, or by cooling,
as at sunset.
Neglecting minor effects, the amount of gas which is needed
to just balance the load at the maximum or floating ele-
vation would also just balance the load at any lower level,
including the surface, al~ugh the balloon would be less
than completely full at such a lower level.
B. Load Limits
For a given lifting gas, the altitude to which a balloon
will rise is determined principally by the load it bears.
Yii th a 20•foot General Mills balloon, using helium, a
payload of 40 pounds will reach approximately 46,000
feet and an 18-pound load will go to about 58,000 feet.
Although the manufacturers recommend keeping the payload
between 18 and 40 pounds, no trouble has been folli~d in
launching loads of as much as 70 pounds (37,000.feet) or
as small as 4 pounds (67,000 feet).
C. Appendices
For·highest altitudes and smallest sunset effects on a bel-
loon, it is necessary to keep air from diluting the helium.
To accomplish this, a check valve is required in order
that helium may be valved when the balloon is full, yet
air not be permitted to enter at any time. An appendix,
consisting of a tube of balloon material, whose length is
about 2 to ~ times its diameter is used for this purpose,
and is supplied as part of the General Mills balloon.
-8-

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.