Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

  • p. 129 …6099 2 HQ AMC WRIGHT PAT 342-seA-6191 CAMBRIDGE LABS 342-A~ AMC HQ WRIGHT…
  • p. 228 …overhead and followed the balloons out to sea. I have no idea about the results that…
  • p. 235 …the regular 334 that we had at sea level. From that they could deduce the temperature…
  • p. 279 …actually located on the jurisdictional lines between Sea Girt and Springlake, New Jersey. It was an…
  • p. 280 …The Sea Girt Inn? A: Exactly. That's where John had his office, and I was…
  • p. 400 …alone 1a about 24,000.m1lea at sea level, aDd about '500 allea at 45,000…
  • p. 407 …five (25) feet at their ls.rgest sea-level diameter. The sonic unit was a combination…
  • p. 466 …hour when one-fifth inf~ated at sea level). One other type of balloon which has…
  • p. 490 …Let us, then, compare the rate of leakage at any given altitude with leakage at sea…
  • p. 492 …The leakage at any altitude may be expressed as a function of leakage at sea level…
  • p. 493 Comparing rete of leakage at 40,000 feet with leakage at sea level: ~ 188 .u§. - 0…
  • p. 495 …It a 20-foot diameter balloon~ full were tested at 10 sea level and found to…
  • p. 496 …At sea level this is equivalent to 5.32 ~r. for a 20-foot diameter balloon…
  • p. 502 …Using the rules of subsonic aerodynamics, Picard suggests that air at sea level escaping at 1333…
  • p. 503 …sea level (psi) escape velocity of air to produce back pressure of 1 atmosphere at sea…
  • p. 520 …to about 20 millibars and increased to sea-level pressure at different temperatures. The most comprehensive…
  • p. 654 …The height above mean sea level as determined fram pressure measurements used in this work with…
  • p. 686 …to a thtmble a.nd attached to re1n forced pCltches at alterna.te .sea.m.s…
  • p. 688 …lQr9e Ba.lloo n ~hould trQin de .sea nd to 101000'. 6 each.-Gene ral M1lls…
  • p. 736 …point at which the radiosonde reaches the sea surface. 2. Earlier attempts There have been numerous…
  • p. 737 …The balloons floated between the surface and 30,000 ft above sea level; those which reached…
  • p. 801 …Vet Gifford ;.;ho has 0 0' sea rescue boat this project is planning to use. Stayed…
  • p. 816 …Worzel working on gravity at sea. Saw Geo Woollard and the Ryders. Woollard after Guggenheim fellowship…
  • p. 887 …the launching site is markedly different from sea level, a shift in this curve is needed…
  • p. 925 …balloon at all times with respect to sea level. On this curve also it is customary…
  • p. 933 …The height above ~ean sea level as determined from pressure measurements used in this work with…
132
BALLAST INI.IT TUBE
FIG. 2.. \utomatic ballast valve.
a diaphragm-operated needle valve which jettisons
liquid ballast whenever the balloon is below the alti-
tude at which the control is actuated. This is shown in
fig. 2. The ballast reservoir (fig. 3), in general, can
hold 15 kilograms of the liquid ballast-usually com-
pass fluid, a highly refined kerosene-type petroleum
product. When the atmospheric pressure outside the
diaphragm is 5 millibars above the internal pressure,
160 grams of ballast per minute flow under a one-foot
head. When the automatic ballast valve is wide open,
which is after 6.5 millibars increase over the internal
pressure, 300 grams per minute flow. These values may
be compared with a diffusion loss of lift of the order
of magnitude of 10 grams per hour from the thicker
15-ft balloon described below. Quite positive altitude
control can be obtained.
Efforts are made to cause the static rate of leakage,
i.e., the leakage which proceeds when the automatic
ballast valve is closed, to exceed slightly the rate of
loss of lift due to the diffusion of the lifting gas from
the balloon. To facilitate setting the fixed leak, a
manually operated ballast valve, consisting of a leak
adjustable by means of a fine needle valve, is added to
the ballast-release assembly. 4
C. lJ;finimum pressure switch.-0bvious1y, the auto-
matic ballast valve must not be in operation while the
balloon is rising, as this would be a waste of ballast.
Therefore the automatically operated needle valve is
closed until the balloon reaches altitude. This is ac-
complished by having the loaded diaphragm of the
altitude control open to the atmosphere until the
balloon descends from a minimum pressure ..-\t this
time, an electrical contact is made and a squib6 cuts a
' Since this manuscript was written, the procedure has been
simplified. Only a simple fixed leak is used for daytime flights.
The automati~ ballast valve is used alone for Rights through
sunset or sunnse.
1 A small electrically detonated charge.
VoLUME 5
restraining cord and allows a needle valve to seal off
the diaphragm from any further access to the air
(fig. 2). The capsule then contains a volume of air
which has been trapped at the existing pressure an'd
temperature, at the time of operation of the sealing
switch. Thereafter the aneroid will withdraw the
ballast-control needle valve when the ambient pressure
increases to the point where the entrapped air is com-
pressed below this volume.
Fig. 4 shows the minimum pressure switch which
makes the electrical contact at the time of seal-off. It
consists of a trapped volume of air that is allowed to
escape through a mercury pool as long as the outside
pressure is decreasing. As soon as the exterior pressure
increases once more, however, mercury is drawn into
the tube, making the seal-off contact between two
electrodes.
4. Height determination
Up to the present time, the standard radiosonde has
been used in order to determine the altitude at which
the balloon is flying. This permits a regular radiosonde
ascent to be obtained during the period that the bal-
loon is rising. Thereafter, as the balloon remains at
approximately the same altitude, it becomes somewhat
difficult to identify the radiosonde contact, but utiliz-
ing both the temperature and pressure indication, this
is possible. A special radiosonde modulator of the
Olland type has been designed (fig. 5). The pressure
BATTERY BOX
VENT TUBE
DISCHARGE TUBE
FIG. 3. Ballast-release assembly.

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.