Documents / FOIA release
roswell
Office of the Secretary of Defense · 993 pages · text from the file's own layer
The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.
“Gross”26 pages
- p. 143 …Robert Gross ar.d 't!r. Jlaher of Lockheed
11~ 55 A.'.!. Gen. Sam Anderson
12…
- p. 481 …Balloon Volume x Gas Lift
Gross Load ·
It may be noted from this equation that a…
- p. 482 …Balloon Volume x 24.4
Gross Load
K
=-w
K _ 08.o475Z
In turn, w-in…
- p. 483 …free lift in pounds
and G is gross lift in pounds.
Although this equation was derived…
- p. 488 …By equation
{10), with a gross load of 52 kg., the unbalance caused by loss
of…
- p. 500 …or a gross
buoyancy of 450 lb. • the maximum allowable infle.tion of a 30'
diameter…
- p. 569 …accelerating
force equal to 5% of the gross load (52 kg) was acting to bring the…
- p. 643 …000 feet.
In one step, this becomes:
Gross Lift/Balloon = (Balloon Volume) x (Difference in molecular…
- p. 650 (Approximate)
where G • gross load
A chart, Figure 24, has beendrawn up, based on this equation…
- p. 652 …G = loss of lift
G =gross load (balloon weight plus
equipment load)
AT : mean temperature difference…
- p. 653 …not including balloon or its integral
parts.
Gross load: Load on the gas at release (Balloon…
- p. 726 …Ballast • • .. • • '" •
Total Equipment l~eight. • • • • '
Gross Load • • ' • • • •
{56)
- p. 727 …Balloon volwne x gas litt/mol
gross load
cu. ft.
-----------------NAximum Altitude • • • ft, m.s.l…
- p. 741 …altitude deter-
mined by the displacement and gross load.
7. Control systems
Two systems of control…
- p. 777 …By adjusting th~ gross load to be
supported by the gas to equal the total lift…
- p. 787 …Computations
A chart showi~ the relation between altitude, gross lift, and
balloon size has been found…
- p. 883 …The gross load reported should be
accurate to the nearest 200 grams. The amount of lifting…
- p. 885 …A L L 0 0 N
7300 ,, GRoss LoAD
Fl G. 17
NYU BALLOON pROJECT I…
- p. 887 …bubble length and resultant inflated volume,
using gross lift as an expression of volume. It will…
- p. 889 …in Appendix II summarizes the relationship between gross
load and floating level for balloons of several…
- p. 925 …A can of sand
is made to weigh the same amount as the required gross lift…
- p. 933 …the balloon with the equipment
load attached.
Gross Lift: Lift of all of the gas in…
- p. 938 …description.______________
Drag chute ----------------------------
Banner description --------------- ----------
Ballast assembly - description -----------~--
Ballast • • • • • •
Total Equipment i'ieight • • ' • • • • • •
Gross Load • • • • • • • • • • •
-86-
- p. 939 …wnitin_,g________ grams
Actual balloon lift • • • • • • • • ". . .•
II
AActunl gross lift (Balloon lift & balloon wt.) •
Number Helium…
- p. 943 …Gross Lift vs. Bubble Length • • • • • • .107
Graph 3: Buoyancy vs. Altitude • • • • • • • • • .108
Graph 4: Gross Load…
- p. 955 …BALLOOO DA 'fA
General Mills Actual Balloon Estimated Gross Altitude
~ominal Diiameter Volwne Weight Load Limit…
With these and subsequent rigging lines the following technique was used:
on all lines a strength test was made and a safety factor of at least ten
to one was demanded. Most of the lines used are of braided or woven nylon.
ohosen for its low weight-strength ratio. To facilitate handling of the
line segments each length is prepared with a small hook on either end. The
knots employed are double carriok bends.
The total length of the early trains reached as much as eight hundred
feet. making them extremely difficult to release. A system of restraining
the load line was evolved with two winches paying out restraining lines
while balloons and equipment were added to the load line. .In this way the
pull of the balloons themselves and the much greater strain caused by even
light winds was held by winches. When the final piece of equipment was
clear of the ground (crwhen the entire flight line was under tension with
the lowest element being held back) a gunpowder squib was electrically fired
to sever the restraining lines near the bottom of the balloon. Figure 27
shows the ahun.inum "cannon" holding the gunpowder, the two winch lines and
a light line used to pull the restraining· lines away £ram the load line after
firing. The load line has not yet been attached in Figure 21. but will be
fixed just above the "cannon".
When the restraining line is severed, there is danger of a pendulum
swing of the train causing the lower components to be dashed into the ground.
To avoid this action, the lowest piece of equipment is usually held by a
member of the crew on the back of a truck. By driving downwind raster than
the surface wind speed, the pull of the balloon can be resolved into only a
vertical component and the equipment may be safely released when the truck
gets under the balloon.
With later plastic cell flights, this method of launching was also
used in cases of light wind. \'vhen windG of about 6 knots are enooun"tered,
- 24 -
About this file
FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.