Documents / FOIA release
roswell
Office of the Secretary of Defense · 993 pages · text from the file's own layer
The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.
“Sea”26 pages
- p. 129 …6099 2 HQ AMC WRIGHT PAT
342-seA-6191 CAMBRIDGE LABS
342-A~ AMC HQ WRIGHT…
- p. 228 …overhead and followed the
balloons out to sea. I have no idea about the results that…
- p. 235 …the regular 334
that we had at sea level. From that they could deduce the
temperature…
- p. 279 …actually located on the jurisdictional lines between
Sea Girt and Springlake, New Jersey. It was an…
- p. 280 …The Sea Girt Inn?
A: Exactly. That's where John had his office, and I was…
- p. 400 …alone 1a about 24,000.m1lea at sea level,
aDd about '500 allea at 45,000…
- p. 407 …five (25) feet at their ls.rgest sea-level diameter. The sonic
unit was a combination…
- p. 466 …hour when one-fifth inf~ated at sea level).
One other type of balloon which has…
- p. 490 …Let us, then, compare the rate of
leakage at any given altitude with leakage at sea…
- p. 492 …The leakage at any
altitude may be expressed as a function of leakage at sea
level…
- p. 493 Comparing rete of leakage at 40,000 feet with leakage at
sea level:
~ 188 .u§. - 0…
- p. 495 …It a 20-foot diameter balloon~ full were tested at
10
sea level and found to…
- p. 496 …At sea level this is equivalent to 5.32 ~r. for a 20-foot
diameter balloon…
- p. 502 …Using the rules of subsonic aerodynamics, Picard
suggests that air at sea level escaping at 1333…
- p. 503 …sea level (psi)
escape velocity of air to produce back pressure
of 1 atmosphere at sea…
- p. 520 …to about 20 millibars and increased to sea-level pressure at
different temperatures.
The most comprehensive…
- p. 654 …The height above mean sea level as determined fram
pressure measurements used in this work with…
- p. 686 …to a thtmble
a.nd attached to re1n forced pCltches
at alterna.te .sea.m.s…
- p. 688 …lQr9e
Ba.lloo n ~hould trQin de .sea nd to 101000'.
6 each.-Gene ral M1lls…
- p. 736 …point
at which the radiosonde reaches the sea surface.
2. Earlier attempts
There have been numerous…
- p. 737 …The
balloons floated between the surface and 30,000 ft
above sea level; those which reached…
- p. 801 …Vet Gifford ;.;ho has
0 0' sea rescue boat this project is planning to use. Stayed…
- p. 816 …Worzel
working on gravity at sea. Saw Geo Woollard and the Ryders. Woollard after Guggenheim
fellowship…
- p. 887 …the launching site is
markedly different from sea level, a shift in this curve
is needed…
- p. 925 …balloon
at all times with respect to sea level. On this curve also
it is customary…
- p. 933 …The height above ~ean sea level as determined
from pressure measurements used in this work
with…
inflation he.s been available.
The 20-foot General Mills balloons are inflated through a tube
in such a fashion that the gas collects in a bubble at the top of the
balloon. !he tube is inserted by the manufacturer and is shown in Figure 5.
It this bubble is restricted, the wind cannot catch and make a sail of' it.
(See figure 25 tor the sail effect.) The actual technique of inflation is as
follows&
In actual inflation the balloon is spread out on a ground cloth
which covers the launching table and a balance. The balloon is
arranged so the upper 18 feet projects beyond the balance. Two
heavy (80#=) elliptical shot bags '(see ~;igure 26) are covered with
polyethylene and placed on top of the balloon on either side of' the
inflation tube. The platform is then made to balance. The lower
end of the balloon is weighed and then stretched out again dov.n wind,
held down with sand bags and polyethylene strips. A weight equal to
the weight of the lower half of the balloon, plus the equipment weight
and the desired tree lift b placed on the balance. Inflation is
started, taking care to get all twists out of 1he inflation tube
before allowing .tull gas flow. When the balance beam falls, in-
flation is complete (care must be exercised to guard against under-
inflation due to wind moving the balloon on the balance). The in-
flation tube is carefully removed, and the helium truck is moved clear.
All personnel are now positioned for release.
B. Release
During the early portion of the experimental period, flignts of
meteorological balloons in clusters were launched. The first flights were
made with balloons hitched one above another along a single strong load line.
- 23 -·
About this file
FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.