Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

Open the PDF at page 646 Original source ↗

“Sea”26 pages

  • p. 129 …6099 2 HQ AMC WRIGHT PAT 342-seA-6191 CAMBRIDGE LABS 342-A~ AMC HQ WRIGHT…
  • p. 228 …overhead and followed the balloons out to sea. I have no idea about the results that…
  • p. 235 …the regular 334 that we had at sea level. From that they could deduce the temperature…
  • p. 279 …actually located on the jurisdictional lines between Sea Girt and Springlake, New Jersey. It was an…
  • p. 280 …The Sea Girt Inn? A: Exactly. That's where John had his office, and I was…
  • p. 400 …alone 1a about 24,000.m1lea at sea level, aDd about '500 allea at 45,000…
  • p. 407 …five (25) feet at their ls.rgest sea-level diameter. The sonic unit was a combination…
  • p. 466 …hour when one-fifth inf~ated at sea level). One other type of balloon which has…
  • p. 490 …Let us, then, compare the rate of leakage at any given altitude with leakage at sea…
  • p. 492 …The leakage at any altitude may be expressed as a function of leakage at sea level…
  • p. 493 Comparing rete of leakage at 40,000 feet with leakage at sea level: ~ 188 .u§. - 0…
  • p. 495 …It a 20-foot diameter balloon~ full were tested at 10 sea level and found to…
  • p. 496 …At sea level this is equivalent to 5.32 ~r. for a 20-foot diameter balloon…
  • p. 502 …Using the rules of subsonic aerodynamics, Picard suggests that air at sea level escaping at 1333…
  • p. 503 …sea level (psi) escape velocity of air to produce back pressure of 1 atmosphere at sea…
  • p. 520 …to about 20 millibars and increased to sea-level pressure at different temperatures. The most comprehensive…
  • p. 654 …The height above mean sea level as determined fram pressure measurements used in this work with…
  • p. 686 …to a thtmble a.nd attached to re1n forced pCltches at alterna.te .sea.m.s…
  • p. 688 …lQr9e Ba.lloo n ~hould trQin de .sea nd to 101000'. 6 each.-Gene ral M1lls…
  • p. 736 …point at which the radiosonde reaches the sea surface. 2. Earlier attempts There have been numerous…
  • p. 737 …The balloons floated between the surface and 30,000 ft above sea level; those which reached…
  • p. 801 …Vet Gifford ;.;ho has 0 0' sea rescue boat this project is planning to use. Stayed…
  • p. 816 …Worzel working on gravity at sea. Saw Geo Woollard and the Ryders. Woollard after Guggenheim fellowship…
  • p. 887 …the launching site is markedly different from sea level, a shift in this curve is needed…
  • p. 925 …balloon at all times with respect to sea level. On this curve also it is customary…
  • p. 933 …The height above ~ean sea level as determined from pressure measurements used in this work with…
sample stations. Figure 21 shows the calculated net lift of the General
Mills balloons.
c. Balloon Diameter-Weight Relationships
To facilitate design discussions, charts have been drawn up
relating the approximate weight of a balloon to its size and the unit
weight of the balloon fabric. A ten percent increase is added to the
weight over that determined from the surface area to account for seams
and shroud lines. Figures 22 and 23 are these charts.
D. BJLte of Rise
It is important that the rate of rise of a balloon be neither
too fast nor too slow. For example, if a General ~dlls' 20-foot balloon
rises faster than 900 feet per minute, there is danger of rupturing the
balloon when pressure altitude is reached. On the other hand, if rates
of rise under 400 feet per minute are chosen, since the free lift will
be quite low, there is dange~ of: 1) a slight error in inflation resulting
in the balloon's being unable to lift the equipment, or 2) with a wind much
in excass of the rate of rise, the up-wind release failing due to the
dragging of the equipment prior to its be1ng lifted by the balloon.
To compute the tree lift necessary for a given rate of rise, the
equation developed by Korft4 is used. This equation is:
V : 412 (F) j-
(G) f
where F =f~ee lift in grams
V : rate of rise in feet per minute
G : g~oss lift in grams
For our purposes, we wish to find F and have modified the equation
to reads
- 18 -

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.