Documents / FOIA release
The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.
“Gross”26 pages
the balloon can rise slowly until the balloon is again full and the equilibrium is again reached between the buoyancy and the load. In tb3 General Mills 20-foot balloon, for example, diffusion losses equal about 300 grams per hourJ the balloon at its ceiling of 50,000 feet, with a 30-pound payload, risea about 900 feet with each kilogr~ of ballast dropped. This means that a balloon, using the simple ballast-dropping technique, will float at a ceiling·which rises at the rate of about 360 feet per hour. An idealized flight of this type is shown in the llolid curve of Fig. 7., neglecting the oscillation shown at sunset. The "manual ballast valve" Which was developed for this simple control system is shown in Fig. a. This valve can be adjusted prior to balloon release to allow any predetermined flow of compass fluid up to 2000 grams per hour. The filter housing and ballast reservoir used with this valve are shown in Figures 9 and 10. This method is good where l) a slowly rising ceiling can be tolerated, and 2) the flight tloes not have to go thrcugh a sunset while at its ceiling. For economy of ballast, hence longer flight duration, it is desirable to keep the constant flow as close as possible to the total loss of buoyancy resulting from diffusion and leakage. This means that whenever rapid loss of buoyancy occurs, due to changes in solar radiation, the manual ballast valve alone will not sustain the balloon. When the balloon is suddenly cooled, due to sunset or clouds cutting off in§olation (loss of superheat), the heavy loss will start the balloon downward and only a rapid expenditure of ballast will check its fall and restore its stability. The second type of ballast dropping control has been devised to operate on a demand basis, when such a descent occurs. This control is called the automatic ballast valve. Figures 11, 12 and 13 shaw the ap- pearance and design of this pressure-actuated needle valve. - 7 -
FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.