Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

  • p. 143 …Robert Gross ar.d 't!r. Jlaher of Lockheed 11~ 55 A.'.!. Gen. Sam Anderson 12…
  • p. 481 …Balloon Volume x Gas Lift Gross Load · It may be noted from this equation that a…
  • p. 482 …Balloon Volume x 24.4 Gross Load K =-w K _ 08.o475Z In turn, w-in…
  • p. 483 …free lift in pounds and G is gross lift in pounds. Although this equation was derived…
  • p. 488 …By equation {10), with a gross load of 52 kg., the unbalance caused by loss of…
  • p. 500 …or a gross buoyancy of 450 lb. • the maximum allowable infle.tion of a 30' diameter…
  • p. 569 …accelerating force equal to 5% of the gross load (52 kg) was acting to bring the…
  • p. 643 …000 feet. In one step, this becomes: Gross Lift/Balloon = (Balloon Volume) x (Difference in molecular…
  • p. 650 (Approximate) where G • gross load A chart, Figure 24, has beendrawn up, based on this equation…
  • p. 652 …G = loss of lift G =gross load (balloon weight plus equipment load) AT : mean temperature difference…
  • p. 653 …not including balloon or its integral parts. Gross load: Load on the gas at release (Balloon…
  • p. 726 …Ballast • • .. • • '" • Total Equipment l~eight. • • • • ' Gross Load • • ' • • • • {56)
  • p. 727 …Balloon volwne x gas litt/mol gross load cu. ft. -----------------NAximum Altitude • • • ft, m.s.l…
  • p. 741 …altitude deter- mined by the displacement and gross load. 7. Control systems Two systems of control…
  • p. 777 …By adjusting th~ gross load to be supported by the gas to equal the total lift…
  • p. 787 …Computations A chart showi~ the relation between altitude, gross lift, and balloon size has been found…
  • p. 883 …The gross load reported should be accurate to the nearest 200 grams. The amount of lifting…
  • p. 885 …A L L 0 0 N 7300 ,, GRoss LoAD Fl G. 17 NYU BALLOON pROJECT I…
  • p. 887 …bubble length and resultant inflated volume, using gross lift as an expression of volume. It will…
  • p. 889 …in Appendix II summarizes the relationship between gross load and floating level for balloons of several…
  • p. 925 …A can of sand is made to weigh the same amount as the required gross lift…
  • p. 933 …the balloon with the equipment load attached. Gross Lift: Lift of all of the gas in…
  • p. 938 …description.______________ Drag chute ---------------------------- Banner description --------------- ---------- Ballast assembly - description -----------~-- Ballast • • • • • • Total Equipment i'ieight • • ' • • • • • • Gross Load • • • • • • • • • • • -86-
  • p. 939 …wnitin_,g________ grams Actual balloon lift • • • • • • • • ". . .• II AActunl gross lift (Balloon lift & balloon wt.) • Number Helium…
  • p. 943 …Gross Lift vs. Bubble Length • • • • • • .107 Graph 3: Buoyancy vs. Altitude • • • • • • • • • .108 Graph 4: Gross Load…
  • p. 955 …BALLOOO DA 'fA General Mills Actual Balloon Estimated Gross Altitude ~ominal Diiameter Volwne Weight Load Limit…
Figures 2 and 3 shaw the tear-drop cell ot the stressed tape
design developed by General Mills, Inc. The tilm is .001 inch polyethylene,
but_t-welded, with scotch tape laid along the seam to reinforce the seal and
to carry and distribute 1he load. These strips, which converge to the loaa
ring at the bottom, actually support the load.
The overloading ot a General Mills 20-tdot balloon on Flight 12 at
Lakehurst kept the lower end of the balloon open during ascent. The
ceiling was greatly reduced by the resulting dilution ot the helium with
air. On later flights an unsuccessful attempt to minimize this mixing
was made, using a 10-toot external appendix passing through the shroud
lines. This appendix fouled ir1 the rigging and twisted completely shut,
causing the balloon to burst at pressure-altitude. A moditicationwith
a 10-foot appendix outside the shroud lines also tailed in actual flight.
Figure 4 shows this appendix construction on a General M lls balloon which
is being inflated. The final style is shown in Figures 5 and 6. It con-
sists of a 2-foot external appendix stiffened with cardboard battens.
This is taped on the outside of the load ring. It serves as a one-way
valve which excludes air during ascent but allows the extra helium to
valve freely when the balloon is full. No external appendix can be used
Whenever the rate of rise exceeds 600 feet per minute. For optimum balloon
performance, it has been determined that: 1) the equipment load for the
General Mills 20-foot balloon should be held tinder 30 pounds; 2) ratEBot
rise should be less than 900 feet per minute; and 3) for maximlml altitudes
an external e ppendix is needed; hence 1he limiting rate of rise is about
600 feet per minute in this case.
Several experimental flights have been made using shrouded Dewey
and Almy neoprene balloons, as well as small and large experimental cells in
- 5 -

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.