Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

  • p. 129 …6099 2 HQ AMC WRIGHT PAT 342-seA-6191 CAMBRIDGE LABS 342-A~ AMC HQ WRIGHT…
  • p. 228 …overhead and followed the balloons out to sea. I have no idea about the results that…
  • p. 235 …the regular 334 that we had at sea level. From that they could deduce the temperature…
  • p. 279 …actually located on the jurisdictional lines between Sea Girt and Springlake, New Jersey. It was an…
  • p. 280 …The Sea Girt Inn? A: Exactly. That's where John had his office, and I was…
  • p. 400 …alone 1a about 24,000.m1lea at sea level, aDd about '500 allea at 45,000…
  • p. 407 …five (25) feet at their ls.rgest sea-level diameter. The sonic unit was a combination…
  • p. 466 …hour when one-fifth inf~ated at sea level). One other type of balloon which has…
  • p. 490 …Let us, then, compare the rate of leakage at any given altitude with leakage at sea…
  • p. 492 …The leakage at any altitude may be expressed as a function of leakage at sea level…
  • p. 493 Comparing rete of leakage at 40,000 feet with leakage at sea level: ~ 188 .u§. - 0…
  • p. 495 …It a 20-foot diameter balloon~ full were tested at 10 sea level and found to…
  • p. 496 …At sea level this is equivalent to 5.32 ~r. for a 20-foot diameter balloon…
  • p. 502 …Using the rules of subsonic aerodynamics, Picard suggests that air at sea level escaping at 1333…
  • p. 503 …sea level (psi) escape velocity of air to produce back pressure of 1 atmosphere at sea…
  • p. 520 …to about 20 millibars and increased to sea-level pressure at different temperatures. The most comprehensive…
  • p. 654 …The height above mean sea level as determined fram pressure measurements used in this work with…
  • p. 686 …to a thtmble a.nd attached to re1n forced pCltches at alterna.te .sea.m.s…
  • p. 688 …lQr9e Ba.lloo n ~hould trQin de .sea nd to 101000'. 6 each.-Gene ral M1lls…
  • p. 736 …point at which the radiosonde reaches the sea surface. 2. Earlier attempts There have been numerous…
  • p. 737 …The balloons floated between the surface and 30,000 ft above sea level; those which reached…
  • p. 801 …Vet Gifford ;.;ho has 0 0' sea rescue boat this project is planning to use. Stayed…
  • p. 816 …Worzel working on gravity at sea. Saw Geo Woollard and the Ryders. Woollard after Guggenheim fellowship…
  • p. 887 …the launching site is markedly different from sea level, a shift in this curve is needed…
  • p. 925 …balloon at all times with respect to sea level. On this curve also it is customary…
  • p. 933 …The height above ~ean sea level as determined from pressure measurements used in this work with…
10 16 16
From this survey and a study or aerostatics, ' ' it appeared that
a non-extensible balloon is highly desirable due to the vertical stabili~
exhibited when such a balloon is full of the lifting gas a A non-extensible
balloon with 'no diffusion or leakage through the walls, which could withstand
a high internal pressure, would automatically remain at the densi~ where
the buoyancy of the fUll balloon equaled the load. In practice, control
devices are needed to offset tqe leakage and diffusion of the lifting gas
and to correct for the motion or the balloon due to diurnal changes or
the balloon's temperature and to correct for vertical wind currents in the
atmosp~ere. It was decided to use a pleatio a• the balloon fabric, since
available plastios have suitable characteristics, and are also relatively
inexpensive as compared to coated fabrics.
The desirable properties to be considered in the selection of a
plastic balloon material area
a. Ease of fabrication
b. High tear resistance
o. Light weight
d. High tensile strength
e. Chemical stability
f. Law permeability
g. Low brittle temperature
h. High transparency to heat redie.tion
Table I is a qualitative-characteristics catalog of the film and
fabrics investigated. The date in the table are presented as approximations
because of the great variations of a given prbperty with choice of samples
and test methods. From this study, polyethylene, nylon, saran, and neoprene-
- 2 -

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.