Documents / FOIA release
roswell
Office of the Secretary of Defense · 993 pages · text from the file's own layer
The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.
“Gross”26 pages
- p. 143 …Robert Gross ar.d 't!r. Jlaher of Lockheed
11~ 55 A.'.!. Gen. Sam Anderson
12…
- p. 481 …Balloon Volume x Gas Lift
Gross Load ·
It may be noted from this equation that a…
- p. 482 …Balloon Volume x 24.4
Gross Load
K
=-w
K _ 08.o475Z
In turn, w-in…
- p. 483 …free lift in pounds
and G is gross lift in pounds.
Although this equation was derived…
- p. 488 …By equation
{10), with a gross load of 52 kg., the unbalance caused by loss
of…
- p. 500 …or a gross
buoyancy of 450 lb. • the maximum allowable infle.tion of a 30'
diameter…
- p. 569 …accelerating
force equal to 5% of the gross load (52 kg) was acting to bring the…
- p. 643 …000 feet.
In one step, this becomes:
Gross Lift/Balloon = (Balloon Volume) x (Difference in molecular…
- p. 650 (Approximate)
where G • gross load
A chart, Figure 24, has beendrawn up, based on this equation…
- p. 652 …G = loss of lift
G =gross load (balloon weight plus
equipment load)
AT : mean temperature difference…
- p. 653 …not including balloon or its integral
parts.
Gross load: Load on the gas at release (Balloon…
- p. 726 …Ballast • • .. • • '" •
Total Equipment l~eight. • • • • '
Gross Load • • ' • • • •
{56)
- p. 727 …Balloon volwne x gas litt/mol
gross load
cu. ft.
-----------------NAximum Altitude • • • ft, m.s.l…
- p. 741 …altitude deter-
mined by the displacement and gross load.
7. Control systems
Two systems of control…
- p. 777 …By adjusting th~ gross load to be
supported by the gas to equal the total lift…
- p. 787 …Computations
A chart showi~ the relation between altitude, gross lift, and
balloon size has been found…
- p. 883 …The gross load reported should be
accurate to the nearest 200 grams. The amount of lifting…
- p. 885 …A L L 0 0 N
7300 ,, GRoss LoAD
Fl G. 17
NYU BALLOON pROJECT I…
- p. 887 …bubble length and resultant inflated volume,
using gross lift as an expression of volume. It will…
- p. 889 …in Appendix II summarizes the relationship between gross
load and floating level for balloons of several…
- p. 925 …A can of sand
is made to weigh the same amount as the required gross lift…
- p. 933 …the balloon with the equipment
load attached.
Gross Lift: Lift of all of the gas in…
- p. 938 …description.______________
Drag chute ----------------------------
Banner description --------------- ----------
Ballast assembly - description -----------~--
Ballast • • • • • •
Total Equipment i'ieight • • ' • • • • • •
Gross Load • • • • • • • • • • •
-86-
- p. 939 …wnitin_,g________ grams
Actual balloon lift • • • • • • • • ". . .•
II
AActunl gross lift (Balloon lift & balloon wt.) •
Number Helium…
- p. 943 …Gross Lift vs. Bubble Length • • • • • • .107
Graph 3: Buoyancy vs. Altitude • • • • • • • • • .108
Graph 4: Gross Load…
- p. 955 …BALLOOO DA 'fA
General Mills Actual Balloon Estimated Gross Altitude
~ominal Diiameter Volwne Weight Load Limit…
I
1301
i
i
t'..,;
% no:. I
l
205 215 225
-mb ..
Figure 31. Tests of Olle.nd-c~·cle performance.
Hysteresis at any one temperature was the worst serious cause
of the width of the envelope of curves. However, this
error was minimized by the smoothness of the rotating cylinder
and the continuous motion of the cylinder under the contact
pen. Probably the necessary looseness of the bearings and
the joining to the motor gear train had a great deal to do with
the spread between different calib~ations.
The maximum variation of any one ce.libration curve from the
mean was about ~3 millibars.
The following recommendations are made for the use of the
Olland-cycle modulator:
(a) The modulator should be mounted inside the battery box and
insulated so as to keep its temperature above -30°C.
(b) During the rapid~rising portion of the flight the accuracy
of the data warrants reading only to the nearest one percent
of a cycle, or about one millibar of pressure.
Tests on the sensitivity of Olland-Cycle modulators indi-
cate that although the accuracy is li~ited as indicated
above, small variations may be detected with the result
that it is valid to read the pressure record to the nearest
tenth of one percent of one revolution.
-'71-
About this file
FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.