Documents / FOIA release
roswell
Office of the Secretary of Defense · 993 pages · text from the file's own layer
The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.
“Gross”26 pages
- p. 143 …Robert Gross ar.d 't!r. Jlaher of Lockheed
11~ 55 A.'.!. Gen. Sam Anderson
12…
- p. 481 …Balloon Volume x Gas Lift
Gross Load ·
It may be noted from this equation that a…
- p. 482 …Balloon Volume x 24.4
Gross Load
K
=-w
K _ 08.o475Z
In turn, w-in…
- p. 483 …free lift in pounds
and G is gross lift in pounds.
Although this equation was derived…
- p. 488 …By equation
{10), with a gross load of 52 kg., the unbalance caused by loss
of…
- p. 500 …or a gross
buoyancy of 450 lb. • the maximum allowable infle.tion of a 30'
diameter…
- p. 569 …accelerating
force equal to 5% of the gross load (52 kg) was acting to bring the…
- p. 643 …000 feet.
In one step, this becomes:
Gross Lift/Balloon = (Balloon Volume) x (Difference in molecular…
- p. 650 (Approximate)
where G • gross load
A chart, Figure 24, has beendrawn up, based on this equation…
- p. 652 …G = loss of lift
G =gross load (balloon weight plus
equipment load)
AT : mean temperature difference…
- p. 653 …not including balloon or its integral
parts.
Gross load: Load on the gas at release (Balloon…
- p. 726 …Ballast • • .. • • '" •
Total Equipment l~eight. • • • • '
Gross Load • • ' • • • •
{56)
- p. 727 …Balloon volwne x gas litt/mol
gross load
cu. ft.
-----------------NAximum Altitude • • • ft, m.s.l…
- p. 741 …altitude deter-
mined by the displacement and gross load.
7. Control systems
Two systems of control…
- p. 777 …By adjusting th~ gross load to be
supported by the gas to equal the total lift…
- p. 787 …Computations
A chart showi~ the relation between altitude, gross lift, and
balloon size has been found…
- p. 883 …The gross load reported should be
accurate to the nearest 200 grams. The amount of lifting…
- p. 885 …A L L 0 0 N
7300 ,, GRoss LoAD
Fl G. 17
NYU BALLOON pROJECT I…
- p. 887 …bubble length and resultant inflated volume,
using gross lift as an expression of volume. It will…
- p. 889 …in Appendix II summarizes the relationship between gross
load and floating level for balloons of several…
- p. 925 …A can of sand
is made to weigh the same amount as the required gross lift…
- p. 933 …the balloon with the equipment
load attached.
Gross Lift: Lift of all of the gas in…
- p. 938 …description.______________
Drag chute ----------------------------
Banner description --------------- ----------
Ballast assembly - description -----------~--
Ballast • • • • • •
Total Equipment i'ieight • • ' • • • • • •
Gross Load • • • • • • • • • • •
-86-
- p. 939 …wnitin_,g________ grams
Actual balloon lift • • • • • • • • ". . .•
II
AActunl gross lift (Balloon lift & balloon wt.) •
Number Helium…
- p. 943 …Gross Lift vs. Bubble Length • • • • • • .107
Graph 3: Buoyancy vs. Altitude • • • • • • • • • .108
Graph 4: Gross Load…
- p. 955 …BALLOOO DA 'fA
General Mills Actual Balloon Estimated Gross Altitude
~ominal Diiameter Volwne Weight Load Limit…
the same time that ballast is normally required in flight. T.his
system simulates the effect of rising and falling in the atmosphere
and indicates the effectiveness of the controls which have been app~d.
In order to simulate flight, it is necessary that three conditions
be mainta·ined within the system. The first is that a leak of air
into the bell jar is pennitted at a rate of pressure increase which
has been observed during balloon descent. A large lag chamber is
connected into the bell jar to supply the second condition which
is a delay similar to that inherent in the control action on an actual
balloon flight. It is •necessary to properly adjust the vo!ume of
such a lag chamber to obtain the desired magnitude of control action.
A third requirement is that the response of the vacuum pump must
correspond to that response which has been observed when a balloon
system drops ballast. In order to measure this, the control me-
chanism has been allowed not only to switch the vacuum pump on and
off but also to actuate the standard ballast-flow equipment. This
system may be adjusted so that the amount of pressure change which
a single period of pumping produces accurately represents the amount
of ballast thrown off during flight.
T.he barogram shown in Figure 18 is e.n example of such a test. On
this test the re.te-of-ascent ballast switch v.ras added to the displace-
•Hours •
Fhaht Samahtude Record Of Pressure
A- Oasplacement Swatch
OperatanQ.
B- Oaspl. a Rate Of Ascent-
Swatches OperahnQ.
Figure 18. Sample barograph record.
ment switch after the latter had operated for a period of six hours.
The combination of the two is seen to have effected a reduction in
-26-
About this file
FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.