Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

  • p. 234 …I think he was still at Bradley Beach, Sharp River Hills Hotel there near Belmar, New…
  • p. 448 …11-.3 2/2'5o II II " 50,000 MOore's Hill, Ind. "-4 2/9…
  • p. 698 …j· :.;1.1 - ~+-Hill~~-ti11'•! :-r:~l-~~'.: L~ ! ; '! :; ! ; ; lj l .: ' ! . . ! . . ! ~ ! l 1 I ; ! '' ~- i ; ; ~ . : j 'I…
  • p. 767 …2/24/47 General :Hills Minneapolis, Minn. Mr. 0. c. ~inzen Request for quotation Quotation supplied…
  • p. 768 …Same request as letter to General Hills 2./';;.4. Requesting that poly- ethylene film that had…
  • p. 805 …Used sonobuoy at 160' hill back of labs. · Jan 10 Fri. Oakhurst. Into ~·Iatson Labs at…
  • p. 863 Figure 1 General Hills 20 foot balloon in flight with 2 foot appendix, stiffened with cardboard…
and distribute the load. These tapes. which converge to the·
load ring at the bottom, actually support the load (Figure 6) •
.An open bottom penni ts the escape of' excess lifting gas and thus
prevents rupture.
BALLOON
i
APPENO:;--XI --··-.
RING ~-.......
Figure 6. Appendix detail, polyethylene balloon.
On the Winzen balloons, which are made from .015" polyethylene,
all but two of' the balloons were made with similar tiber tape re-
inforcementsJ these two were produced without tapes and both of
them have been flown with no evidences of unsatisfactory perfor-
mance.
The eggplant shaped balloon produced by The Goodyear Tire & Rubber
Company, Inc. has been flown with satisfaction, but the exact
amount of diffusion, which is expected to be low from this balloon,
h not yet known.
C. Internal-Pressure Balloons
From a theoretical standpoint the most satisfactory means of' keeping
a balloon at constant pressure-altitude is to use a nan-extensibl•
-14-

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.