Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

Open the PDF at page 432 Original source ↗

“Fort Worth”32 pages

  • p. 12 …Fort Worth Star-Telegram, Photographs of Balloon Debris, July 9, 1947 17. Satement, Lt. Col. Sheridan…
  • p. 13 …Fort Worth Star-Telegram, Photographs of Balloon Debris, July 9, 1947 2. Organizational Chart, Watson Laboratories…
  • p. 30 …These locations include Fort Worth, Texas, the home of the Eighth Air Force Headquarters; possibly Sandia…
  • p. 34 …DC; Federal Records Center, Ft Worth, TX; the INSCOM Archives, Fort Meade, MD; National Air and…
  • p. 38 …in the famous photos (Atch 16) in Fort Worth was that of a radar target normally…
  • p. 39 …were told was a flying saucer to Fort Worth. The people on board included ... and Maj…
  • p. 40 …Newton was a weather officer assigned to Fort Worth, who was on duty when the Roswell…
  • p. 45 …photographs taken at the time by the Fort Worth Star-Telegram, that depicted Ramey and Marcel…
  • p. 46 …the wreckage prior to its getting to Fort Worth. This organization reported on July 20, 1994…
  • p. 51 …After the autopsies, conspiracy theorists said the bodies were flown to Fort Worth and then to…
  • p. 75 …Some of the debris was flown to Fort Worth, ..as where the Commander of the Eighth…
  • p. 101 …Center (WNRq or the Southwest Regional Depository (Fort Worth, Texas). Recommendations Because the records management policy…
  • p. 151 16 Fort Worth Star-Telegram Photographs of Balloon Debris July 9, 1947
  • p. 159 …taken to Eighth AU- Force Headquarters in Fort Worth where it was subsequently identified as a…
  • p. 167 …Marcel took it to Fort Worth. Yeah that's the ... RW: ·Yeah. That doesn't look…
  • p. 168 …into Wright-Pat and Kirtland, or to Fort Worth. Back and forth, loaded up, with very…
  • p. 174 …Then it said: "After Marcel had gone to Fort Worth and came back Marcel challenged the…
  • p. 176 …O.K."Marcel would take some ofthe sample to Fort Worth to show Ramey. In the…
  • p. 179 normal course of his duty was sent to Washington not 8th Air Force in Fort Worth…
  • p. 254 …But the Roswell morning paper clearly showed that there was a knowledgeable person in Fort Worth…
  • p. 266 …Headquarters by a news photographer of the Fort Worth Star Telegram. It's four pictures that…
  • p. 309 …I was the only weather forecaster on duty in the Fort Worth base weather and flight…
  • p. 318 …flown to Eighth Air Force Headquarters at Fort Worth AAF, TX, for his personal inspection. Upon…
  • p. 326 …Before the announcement was made, the "disc" was flown to Fort Worth AAF, at the direction…
  • p. 327 …giant thermos jug" was allegedly transported from Fort Worth AAF to Wright Field. 38 This description…
  • p. 329 designs on it."41 Furthermore, the Fort Worth Army Airfield Weather Officer, Irving Newton, who was…
  • p. 333 Fort Worth Star-Telegram Photographs of Balloon Debris July 9, 1947 1
  • p. 640 …Similarly, the Fort Worth Sub-Committee established a procedure for flights made within the Fort V1orth…
  • p. 707 …Air Coordinating Committee, Fort Worth Regional Airspace Subcommittee. Subject: Obstructions to ·air navigation ••••.•••••••••••••••••••••••••• 43 Memorandum from…
  • p. 713 …Secretary a SUBJECT AIR COORDINATING COMMITTEE FORT WORTH REGIONAL AIRSPACE SUBCOMMITTEE P. O. BOX 1689 FORT…
  • p. 715 …BOX 1689 FORT WORm 1_ mxAS September 2, 1947 C1-tairman, Ft. Worth Regional Airspace Subcommittee…
  • p. 812 …Arrived in Fort Worth about 9 EDST. Off again to Big Springs, Texas, where forced to…
~.
Output· of the oscillator- is both amplitude and frequency modulated,
the amplitude modulation being limited by a class "0" RF·amplifier.
This unit weighed six 011nces, was fed by a plate voltage of 270
volts with a filament drain of 400ma. at 1.5 volts. The output
was one watt at frequencies from 25 to lOOmc.
Before procurement_or a receiver with automatic frequency control
an attempt was made to develop a crystal controlled oscillator to
overcome the frequency drift inherent in FM systems. This work
was abandoned when the controlled receiver was obtained. The
crystal control unit which was developed required extreme care in
tuning in order that modulation be linear.
A miniature poW'er amplifier, using one dual triode as a pllsh-pull
amplifier was const~tcted for use at 25 to lOOmc with any of the
above mentioned transmitters. The antennae for these transmitters
was a halt-wave vertical dipole.
The receiver found satisfactory for these systems was the R-2A/ARR-3
Sonobuoy receiver. This t~it employs Automatic frequency control
and will tolerate a drift - .J5mc before retuning is required.
When SCR-658 radio direction finding equipment became available
work on these transmitters was abandoned and a 400mc transmitter
used. This system allows for accurate positioning of the balloon
systems by use of crossed azemuths tram se.eral receiving stations.
A transmitter using pulse time modulation was designed for use
with this receiving equipment. The advantages here are high
peak power with relatively low input power (and thus a high
signal to noise ratio) and simultaneous transmission of several
data channels at one frequency. This project was abandoned
before tests could be completed due to a modification or project
reqt irements, but preliminary results indicated that this system
wo1tld be advantageous in AM or FM transmissiOn. This syatem makes
use or sho~t duration pulses ( .5 micro second) at .a repetition
rate or approximately 10 kc.
For long range transmission or information an amplitude-modulated
transmitter was developed. (Fig. 6) This unit, the AM-1, is crystal
controlled, employing a 3A4 miniatnre tube in a Pierce oscillator ·
circuit as the crystal oscillator. This circuit does no.t require ·
an LC tank circuit and eliminates the tuning of this additional
stage. The RF amplifier is ·a 3A5 miniature dual triode tube.
The unit was designed to give lS watt output with a 270 volt
plate supply and can be used with 380 volts to give 3 watt o1itput.

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.