Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

  • p. 408 …Randall S. Kane let Lieutenant Wm. L. Adams M/Sergeant W. L. Halliday M/Sergeant R…
  • p. 810 …Lewis, Wolk, Burnhoff, Adams, Duff • Worked some on instrument calibrations. Lewis, Ball and I checked with…
~.
Output· of the oscillator- is both amplitude and frequency modulated,
the amplitude modulation being limited by a class "0" RF·amplifier.
This unit weighed six 011nces, was fed by a plate voltage of 270
volts with a filament drain of 400ma. at 1.5 volts. The output
was one watt at frequencies from 25 to lOOmc.
Before procurement_or a receiver with automatic frequency control
an attempt was made to develop a crystal controlled oscillator to
overcome the frequency drift inherent in FM systems. This work
was abandoned when the controlled receiver was obtained. The
crystal control unit which was developed required extreme care in
tuning in order that modulation be linear.
A miniature poW'er amplifier, using one dual triode as a pllsh-pull
amplifier was const~tcted for use at 25 to lOOmc with any of the
above mentioned transmitters. The antennae for these transmitters
was a halt-wave vertical dipole.
The receiver found satisfactory for these systems was the R-2A/ARR-3
Sonobuoy receiver. This t~it employs Automatic frequency control
and will tolerate a drift - .J5mc before retuning is required.
When SCR-658 radio direction finding equipment became available
work on these transmitters was abandoned and a 400mc transmitter
used. This system allows for accurate positioning of the balloon
systems by use of crossed azemuths tram se.eral receiving stations.
A transmitter using pulse time modulation was designed for use
with this receiving equipment. The advantages here are high
peak power with relatively low input power (and thus a high
signal to noise ratio) and simultaneous transmission of several
data channels at one frequency. This project was abandoned
before tests could be completed due to a modification or project
reqt irements, but preliminary results indicated that this system
wo1tld be advantageous in AM or FM transmissiOn. This syatem makes
use or sho~t duration pulses ( .5 micro second) at .a repetition
rate or approximately 10 kc.
For long range transmission or information an amplitude-modulated
transmitter was developed. (Fig. 6) This unit, the AM-1, is crystal
controlled, employing a 3A4 miniatnre tube in a Pierce oscillator ·
circuit as the crystal oscillator. This circuit does no.t require ·
an LC tank circuit and eliminates the tuning of this additional
stage. The RF amplifier is ·a 3A5 miniature dual triode tube.
The unit was designed to give lS watt output with a 270 volt
plate supply and can be used with 380 volts to give 3 watt o1itput.

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is above. 993 pages are in the text index: search them above, or from the library's search.