Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

  • p. 143 …Robert Gross ar.d 't!r. Jlaher of Lockheed 11~ 55 A.'.!. Gen. Sam Anderson 12…
  • p. 481 …Balloon Volume x Gas Lift Gross Load · It may be noted from this equation that a…
  • p. 482 …Balloon Volume x 24.4 Gross Load K =-w K _ 08.o475Z In turn, w-in…
  • p. 483 …free lift in pounds and G is gross lift in pounds. Although this equation was derived…
  • p. 488 …By equation {10), with a gross load of 52 kg., the unbalance caused by loss of…
  • p. 500 …or a gross buoyancy of 450 lb. • the maximum allowable infle.tion of a 30' diameter…
  • p. 569 …accelerating force equal to 5% of the gross load (52 kg) was acting to bring the…
  • p. 643 …000 feet. In one step, this becomes: Gross Lift/Balloon = (Balloon Volume) x (Difference in molecular…
  • p. 650 (Approximate) where G • gross load A chart, Figure 24, has beendrawn up, based on this equation…
  • p. 652 …G = loss of lift G =gross load (balloon weight plus equipment load) AT : mean temperature difference…
  • p. 653 …not including balloon or its integral parts. Gross load: Load on the gas at release (Balloon…
  • p. 726 …Ballast • • .. • • '" • Total Equipment l~eight. • • • • ' Gross Load • • ' • • • • {56)
  • p. 727 …Balloon volwne x gas litt/mol gross load cu. ft. -----------------NAximum Altitude • • • ft, m.s.l…
  • p. 741 …altitude deter- mined by the displacement and gross load. 7. Control systems Two systems of control…
  • p. 777 …By adjusting th~ gross load to be supported by the gas to equal the total lift…
  • p. 787 …Computations A chart showi~ the relation between altitude, gross lift, and balloon size has been found…
  • p. 883 …The gross load reported should be accurate to the nearest 200 grams. The amount of lifting…
  • p. 885 …A L L 0 0 N 7300 ,, GRoss LoAD Fl G. 17 NYU BALLOON pROJECT I…
  • p. 887 …bubble length and resultant inflated volume, using gross lift as an expression of volume. It will…
  • p. 889 …in Appendix II summarizes the relationship between gross load and floating level for balloons of several…
  • p. 925 …A can of sand is made to weigh the same amount as the required gross lift…
  • p. 933 …the balloon with the equipment load attached. Gross Lift: Lift of all of the gas in…
  • p. 938 …description.______________ Drag chute ---------------------------- Banner description --------------- ---------- Ballast assembly - description -----------~-- Ballast • • • • • • Total Equipment i'ieight • • ' • • • • • • Gross Load • • • • • • • • • • • -86-
  • p. 939 …wnitin_,g________ grams Actual balloon lift • • • • • • • • ". . .• II AActunl gross lift (Balloon lift & balloon wt.) • Number Helium…
  • p. 943 …Gross Lift vs. Bubble Length • • • • • • .107 Graph 3: Buoyancy vs. Altitude • • • • • • • • • .108 Graph 4: Gross Load…
  • p. 955 …BALLOOO DA 'fA General Mills Actual Balloon Estimated Gross Altitude ~ominal Diiameter Volwne Weight Load Limit…
PROFESSOR MOORE - 6/8/94 6
Q: w.w. Brazel mentions eyelets which appear in the
reflectors. There's also, on the polyethylene balloons, the
shroud however you had it hooked on there. There's eyelets
around the base. There was a ring at the neck of the balloon and
then there were attach points to that ring, were there not?
A: But there were no eyelets.
Q: I believe there were. I've reviewed the New York
University documents and there's a very clear depiction in one of
them of eyelets.
A: Okay, I was thinking of the later ••• Here are the NYU
reports, the originals of them.
Q: In one of the configurations they clearly show eyelets
in the drawing.
Q: Going back to Brazel, you state that you think it could
not be one of the polyethylene balloons. He indicates in this
newspaper article that he actually found the debris in mid-June,
however it didn't subsequently come out until July.
A: You're right. That is in one of the polyethylene
balloons, you're correct. I fall back on my plea that my memory
isn't ...
Q:
about.
It comes into depending on what Brazel was speaking
A: There are clearly eyelets here. In fact there's a
little swivel.
He talks about the smoky gray rubber ••.
Q: Which these samples here, as you say, if they'd only
been out for a short time, a matter of days, smoky gray, that's a
very good description of what they looked like.
A: And when you first retrieve it has a bad odor. And
people talked about there being a burned odor.
We need to talk about these neoprene balloons because they
came in different ..• There were two manufacturers-- one, Dewey
& Olney in Cambridge manufactured with a dip process and they had
very much the appearance, if you will, of a condom. They were an
ivory colored jell. The Kaysam company in Patterson made a cast
neoprene emulsion into a mold~ and then they inflated the mold.
They had to put a lot of plasticizers so they could take this wet
jell and inflate it and make it into a meteorologic balloon.
This is a Kaysam balloon here, which I think is not a good
candidate.
Q: Kaysam?

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.